Run with the old version of the software and a new controller licence. My guess is it's a ports and pins issue, but I can't find in the old software what settings to use in the new. Get the newest version of the software to communicate with the machine. Here's my preferred way of going forward, from most to least desired: Looking for a bit of guidance on this as far as how to best proceed. I'm find with paying for the controller licence, but I'd want to know that worst case, the licence I buy would work with the older version of the software. I tried importing this file into the new version but still no go.
The software that came with the machine also came with a settings file. I attempted to install and run the newest downloadable version of the CNC USB software, but because I couldn't find the port connections in the old software, I wasn't able to get it running.
(I can provide the ebay auction link if that helps) 601) which works (jogs and runs gcode), albeit is restricted to a 25 command run because it is the trial version. It came with what I think is an old trial version of the CNC USB software (ver.
